Adafruit Pimoroni OmniVESA

The Pimoroni OmniVESA is the perfect mounting solution for your Raspberry Pi!

Simply remove the protective backing from the OmniVESA and follow Pimoroni's instructions to mount your Raspberry Pi either bare or in any Pimoroni case! (Some other cases supported too).

The nylon screws provided are long enough to work with all of the relevant cases, though if you find they are protruding too far from the case of your choice you can easily trim them down using some pliers. Just remember to use eye protection when cutting!

The OmniVESA supports 75mm and 100mm spacing mounts.

Kit contains:

1x OmniVESA
2x M4 16mm Nylon Knurled Thumbscrews
2x 5mm Nylon Spacers
2x M2.5 x 16 Nylon Screws
3x M2.5 Nuts