技术细节
| EMI / RFI噪声滤波 |
70 dB |
| EMI / RFI噪声滤波 |
Y |
| 浪涌保护功能 |
A/V, Coax, Fax, Modem, Telephone |
端口 & 界面
| 无绳 |
N |
| 电源插头 |
BS1363A |
| RJ - 11端口数量 |
1 |
能量控制
| 接受频率 |
50/60 Hz |
| 名义电流输出 |
13 A |
| 峰值电流,正常模式 |
40000 A |
| 峰值电流,共同模式 |
30000 A |
| 交流电（AC）插座数量 |
8 AC outlet(s) |
| 能量波动功率 |
2525 J |
| 额定输入电压 |
230 V |
环境条件
| 非运行高度 |
0 - 15000 m |
| 工作高度 |
0 - 15000 m |
8 x UK BS1363 Outlets, 1 x BS1363A In, 2525J, 230V, 50/60 Hz, 13A, EMI/RFI, 3.05m Cord, 1.23kg
Protection from damaging power transients
Protection Working Indicator
SurgeArrest will warn you if its circuitry has been damaged by heavy strike or power line surge and it is unable to provide 100% protection. If still under warranty, APC will then replace your damaged SurgeArrest free of charge.
Overload Indicator
Indicator illuminates when connected equipment draws more power than unit’s capacity. To remedy the condition, unplug less vital equipment.
Right Angle Plug
Plug angle allows for equipment and furniture to be placed closer to the wall than with a standard power cord. Reduces cord stress too.
IEEE let-through ratings and regulatory agency compliance
Stringent third-party testing gives you confidence that APC's surge protectors will safeguard your equipment and data from potentially damaging surges and spikes.
AV Surge Protectors Features & Benefits
Safety
Building Wiring Fault Indicator
Immediately warns you of wiring problems like improper grounds that could cause shocks or prevent adequately suppressing surges.
Catastrophic Event Protection
SurgeArrest components such as MOVs and Thermal fuse ensure instantaneous reaction to lightning strikes and wiring faults. If the surge components are damaged due to power spike or over voltage, excess power cannot reach your equipment. Unlike the APC SurgeArrest products, most surge suppressors continue to let power through even after circuits have been damaged, leaving your equipment exposed to other damaging surges.
Fail Safe Mode
Most other surge suppressors continue to let power through even after their circuits have been damaged, leaving your equipment exposed to future surges. APC’s SurgeArrest fail safe, which means that once the circuit of an APC SurgeArrest has been compromised the unit disconnects equipment from the power supply ensuring that no damaging surges reach your equipment.
IEEE let-through rating and UL 1449 compliance
The 'Institute of Electrical and Electronics Engineers' (IEEE) Let-Through Voltage rating is based on a test that subjects a Surge Protector to a 6,000 volt spike. The rating equates to the amount of excess voltage that reaches connected equipment. The lower the number, the better the performance of the Surge Protector is. Underwriter's Laboratory's UL1449 surge protection safety standard uses these ratings to help users gauge performance. UL's best Transient Voltage Surge Suppressor (TVSS) Let-Through Voltage rating is "300V".
Protection
Noise Filtering
Attenuates EMI/RFI line noise that can cause data errors and keyboard lockups, ensuring better performance of protected equipment.
