性能
噪音水平 |
40 dB |
波形 |
Sine |
浪涌保护 |
Y |
能量控制
输入工作电压(最大值) |
266 V |
输入工作电压(最小值) |
180 V |
最大电流 |
10 A |
电源输入频率 |
50/60 Hz |
能量波动功率 |
310 J |
THD输入电流 |
5% |
输出功率(瓦特-安培) |
550 VA |
输出工作电压(最小值) |
220 V |
输出工作电压(最大值) |
230 V |
输出功率 |
330 W |
环境条件
非运行高度 |
0 - 9000 m |
工作高度 |
0 - 9000 m |
端口 & 界面
交流电(AC)插座数量 |
8 AC outlet(s) |
330 W, 230V, USB + WBEXTWAR3YR-SP-01
Battery failure notification\nProvides early-warning fault analysis on batteries enabling timely preventive maintenance\n\nResettable circuit breaker\nEasy recovery from overloads; no need to replace a fuse.\n\nBattery-protected and surge-only outlets\nReserves power capacity and run time for connected equipment that require UPS battery back-up while providing surge only protection for less critical equipment\n\nCold-start capable\nProvides temporary battery power when the utility power is out.\n\nHot-swappable batteries\nEnsures clean, uninterrupted power to protected equipment while batteries are being replaced\n\nDataline Surge Protection\nProvides protection of connected equipment from power surges on the data lines.\n\nAutomatic self-test\nPeriodic battery self-test ensures early detection of a battery that needs to be replaced.\n\nAdjustable voltage sensitivity\nProvides the ability to adapt the UPS for optimal performance in specific power environments or generator applications.\n\nAudible alarms\nProvides notification of changing utility power and UPS power conditions\n\nUser-replaceable batteries\nIncreases availability by allowing a trained user to perform upgrades and replacements of the batteries reducing Mean Time to Repair (MTTR)\n\nUSB connectivity\nProvides management of the UPS via a USB port (not available on all models).\n\nSafety-agency approved\nEnsures the product has been tested and approved to work safely with the connected service provider equipment and within the specified environment.\n\nBattery and surge protected outlets\nBack up and protect your hardware and data during power outages, surges and spikes.\n\nSurge only outlets\nProtect secondary electronics from surges and spikes without reducing battery power used to run primary electronics during an outage.\n\nAutomatic self-test\nPeriodic battery self-test ensures early detection of a battery that needs to be replaced.\n\nBattery failure notification\nProvides early-warning fault analysis on batteries enabling timely preventive maintenance\n\nIntelligent battery management\nMaximizes battery performance, life, and reliability through intelligent, precision charging.\n\nResettable circuit breaker\nEasy recovery from overloads; no need to replace a fuse.\n\nAudible alarms\nProvides notification of changing utility power and UPS power conditions\n\nLED status display\nQuickly understand unit and power status with visual indicators.\n\nSafety-agency approved\nEnsures the product has been tested and approved to work safely with the connected service provider equipment and within the specified environment.