环境条件
| 储存温度范围 (T-T) |
-40 - 85 °C |
| 储存相对湿度范围（H - H） |
10 - 95% |
| 运行湿度范围(H-H) |
10 - 95% |
联网
| 可支持的电缆类型 |
Cat5e, Cat6 |
| 自动检测 |
Y |
| 广播风暴控制 |
Y |
| 自动 MDI / MDI - X 检测功能 |
Y |
| 网络标准 |
IEEE 802.1p, IEEE 802.3, IEEE 802.3ab, IEEE 802.3az, IEEE 802.3u, IEEE 802.3x, IEEE 802.3z |
| 流量控制支持 |
Y |
| 10G支持 |
N |
| 全双工传输 |
Y |
设计
| DIN导轨安装 |
Y |
| 液晶显示器指示灯 |
Y |
| 国际保护（IP）代码 |
IP30 |
| 外壳材料 |
Metal |
| 认证 |
s UL Class 1 Division 2 Groups A,B,C,D; ATEX Zone 2 (pending); IECEx (pending, UL508, FCC Part 15, EN 61000-4-2 (Level 3), EN 61000-4-3 (Level 3), EN 61000-4-4 (Level 3), EN 61000-4-5 (Level 3), EN 61000-4-6 (Level 3), EN 61000-4-8 (Level 3), IEC 60068-2-27, IEC 60068-2-32, IEC 60068-2-6 |
| 墙壁支架 |
Y |
光纤
| 光纤连接器 |
SFP |
| 以太网光缆技术 |
1000BASE-LHX, 1000BASE-SX, 1000BASE‑LX, 1000BASE‑ZX |
性能
| Auto-negotiation 自动协商功能 |
Y |
| 缓冲区大小 |
4100 KB |
| 平均故障间隔时间 |
2825281 h |
| 即插即用 |
Y |
端口 & 界面
| 接线端子台端口 |
Y |
| 基本交换 RJ-45 以太网端口数量 |
16 |
| 基本交换 RJ-45 以太网端口类型 |
Fast Ethernet (10/100) |
| 以太网铜缆技术 |
100BASE-TX, 1000BASE-TX, 10BASE-T |
| Combo SFP 端口数量 |
2 |
重量和尺寸
| 宽度 |
74 mm |
| 高度 |
84 mm |
| 深度 |
120 mm |
数据传输
| MAC 地址表 |
8000 entries |
| 交换容量 |
7.2 Gbit/s |
| 巨型帧 (Jumbo frames) |
9126 |
能量控制
| 输入电压 |
12 - 48 V |
| 功耗（一般操作） |
8.2 W |
| 冗余电源(rps)支持 |
Y |
协议
| 管理协议 |
iView2 , LLDP, SNMP v1/v2c, Modbus/TCP |
以太网电源（PoE）
| 电源保护功能 |
Over current, Reverse polarity |
另外
| 巨型帧 |
Y |
| 产品色彩 |
Blue |
| 运行温度范围（T - T） |
-40 - 75 °C |
Monitored, 16xRJ45, 2xCombo SFP, 8000 MAC, 7.2Gbit/s, 9126 Jumbo Frames, 12-48V, 8.2W, 74x120x84mm, Blue
BRIDGING THE GAP BETWEEN MANAGED AND UNMANAGED SWITCHES
- Built-in Modbus & SNMP features which offer the ability to remotely monitor and analyze network status
- Lite Management for small scale/edge networks needing remote data collection, diagnostics, real time data acquisition.
- IEEE802.3az - Energy Efficient Ethernet
- Operates in a wide temperature range (-40° to 75°)
- Designed for hazardous locations: UL C1D2, ATEX Zone 2 (pending), IECEx (pending)
- iView2 Management Software gives network managers the ability to monitor and manage eWorx SE300 series switches from a central location.DETAILS
Details
SE300 series is the industry’s first design for Ethernet Green, IEEE802.3az - Energy Ethernet switches that cut power usage by up to 60%, significantly saving energy usage in the field and reducing total cost of ownership over 24/7.
Advantech B+B SmartWorx SE300 series monitored switches can be used as plug-and-play unmanaged switches right out of the box. Installing the iView² Network Management Software gives them basic monitoring and management capabilities as well. They bridge the gap between unmanaged switches and significantly more expensive, fully managed solutions.
When enabled with iView2, these switches provide IP address assignment, allowing for a static IP address or an address that is discoverable via DHCP in the network. Then, these switches have the ability to use Modbus/TCP to communicate with HMI/SCADA software and SNMP to communicate with NMS (Networking Management Software) at the same time. This gives full access control to both control engineers and IT managers.
