With flexible arm. The choice for you who use your iPad in the back seat of a car. The iPad mount is placed onto a front seats head rest and has a flexible arm so you can adjust the screen just the way you want. The installation is quick and easy, no special tools are required and the interior will not be damaged. You can connect e.g. a charging cable to the iPad when it is in the holder.
You can easily switch between portrait and landscape mode by turning the holder into desired position. It is easy to put the iPad into place in the holder, and to take it with you when leaving the car. The length of the flexible arm is 27 cm Please read all of the instructions and look at the pictures before attaching the headrest mount.
1. Loosen the screws in the headrest mount so you get two parts. Press the flat part into the gap between the headrest and the front seat's back support. Press the flat part all the way in until it stops. Place the front part of the mount on the back side of the headrest so the screws fit in the holes in the flat part. Tighten the screws on the frontside of the headrest mount, using the enclosed tool. Screw until the headrest mount is properly in place.
2. To place the device in the holder: Place the lower part of the device in the holder, then flip/press the upper part forwards so it snaps into place in the holder. To remove the device from the holder: Press upwards on the upper part of the holder, in the same time pull the upper part of the device out from the holder and then lift the device up and out from the holder.
3. Switch between portrait and landscape mode by turning the holder.
4. The headrest mount is in place.
