Mount for monitors with a vertical slot in back. ONLY for SW. For installation of multimedia screens in vehicles. The screen mount is placed between the front seats, giving the back seat passengers a perfect view. The screen mount comes with a tilt swivel so it can be adjusted in order to avoid light reflection. You can take the screen with you when leaving the vehicle. Installation is quick and easy. The interior of the vehicle will not be damaged, as no drilling holes is required.
The screen mount fits screens with a vertical slot on the back side. Between seats mount, ONLY for SW Attention! Read all instructions and look at the pictures before attaching the screen mount.
1. Peel off the adhesive tape covers on the screen mount. Press/Hook the angled edge on the lower part of the mount under the edge of the floor console, into the gap between the floor and the floor console.
2. Hook the upper part of the screen mount over the edge of the compartment on top of the floor console.
3. The screen mount is in place.
4. The screen mount in place, with a screen attached to it. Place the screen onto the screen mount by sliding it downwards from above onto the nut in the center of the face plate. The rubber ring on the metal piece is to be OUTSIDE the groove on the back of the screen. Tighten the wheel on the back of the screen mount so the screen has a firm fit. The screen can be removed and you can take it with you when leaving the car.