The ProClip is a mounting bracket for the vehicles dashboard. Onto the Proclip you can install e.g. a holder for your mobile phone or PDA or a handsfree set etc. Safe and convenient -always within easy reach. The ProClip is car specific and easy to install. The installation is quick, no special tools or dismantle of the dashboard is required and it will not damage the interior of the vehicle. Made in black ABS plastic. Comes with detailed instructions. Angled mount Attention! Read all instructions before attaching the ProClip.
NOTE: This ProClip can be attached to the dashboard as shown in either position picture # 3 and/or #4. You can also have two ProClips attached, one above the other. For both positions the same directions apply. In the pictures the dashboard may look slightly different from yours i.e. different stereo, buttons for the On Star System, Panel frame etc. but this has been taken into consideration and the ProClip will fit your dashboard.
Peel off the cover of the adhesive tape on the ProClip.
1. Press the angled edge on the left side of the ProClip into the gap between the dashboard and the surrounding panel frame.
2. Press forward on the right side of the ProClip, towards the dashboard, so the angled edge snaps into the gap between the panel frame and the dashboard. (If the gap is tight or if you are attaching the ProClip according to picture #4, press the thin end of the enclosed gap opener into the gap to widen it)
3 and 4. The ProClip is in place.