Brodit ProClip

The ProClip is a mounting bracket for the vehicle’s dashboard. Onto the Proclip you can install e.g. a holder for your mobile phone or PDA or a handsfree set etc. Safe and convenient -always within easy reach. The ProClip is car specific and easy to install. The installation is quick, no special tools or dismantle of the dashboard is required and it will not damage the interior of the vehicle. Made in black ABS plastic. Comes with detailed instructions. Angled mount Attention! Read all instructions before attaching the ProClip.

1. Remove the screw in the panel between the controls and the glove compartment. Press the thin end of the enclosed gap opener into the gap between the panel and the center console below. Use the gap opener to loosen the panel surrounding the controls and pull the panel 5 mm towards you, away from the dashboard. Peel off both adhesive tape covers on the ProClip.

2. Press the upper part of the ProClip into the gap between the pulled out panel and the panel surrounding the air vents.

3. Match the predrilled hole in the lower part of the ProClip with the hole in the panel. Press forward on the panel so it goes back into place. Screw the lower part of the ProClip onto the dashboard using the enclosed screw.

4. The ProClip is in place.