Brodit ProClip

The ProClip is a mounting bracket for the vehicle’s dashboard. Onto the Proclip you can install e.g. a holder for your mobile phone or PDA or a handsfree set etc. Safe and convenient -always within easy reach. The ProClip is car specific and easy to install. The installation is quick, no special tools or dismantle of the dashboard is required and it will not damage the interior of the vehicle. Made in black ABS plastic. Comes with detailed instructions. Angled mount Attention! Read all instructions before attaching the ProClip

1 .Press the enclosed gap opener into the gap at pos. x between the padded dashboard and the air vent frame. Loosen the air vent frame and remove it from the dashboard.

2. Clean the surface at pos. 1 and pos. 2 with the enclosed alcohol pad. Peel off the adhesive covers on the ProClip.

3. Place the upper part of the ProClip at the inner edge of the frame at pos. 1. Hook the lower part of the ProClip under the edge at pos. 2. Peel off both adhesive tape covers on the enclosed adhesive tapes. Attach one adhesive tape on each short side of the frame over the raised bumps

4. Place the left part of the frame back into the dashboard and press it to the left at the same time as you press the right part into the dashboard until it is properly attached.