Brodit ProClip

The ProClip is a mounting bracket for the vehicle’s dashboard. Onto the Proclip you can install e.g. a holder for your mobile phone or PDA or a handsfree set etc. Safe and convenient -always within easy reach. The ProClip is car specific and easy to install. The installation is quick, no special tools or dismantle of the dashboard is required and it will not damage the interior of the vehicle. Made in black ABS plastic. Comes with detailed instructions. Center mount Attention! Please read all of the instructions and look at the pictures before attaching the ProClip. Note: The ProClip can be attached on either side of the air vent. The instructions below apply for both placements.

1. Press the thick end of the enclosed gap opener into the gap between the stereo and the surrounding frame, to widen the gap. Peel off the cover of adhesive tape on the ProClip.

2. Press the angled edge on the upper part of the ProClip into the gap next to the gap opener. Pull out the gap opener.

3. Press upwards and forward on the lower part of the ProClip so the grooved edge hooks over the air vent edge. Press down on the inner side of the ProClip to make sure the grooved edge snapped properly into place. Adjust the air vent.

4. The ProClip is in place.