Brodit ProClip

The ProClip is a mounting bracket for the vehicle's dashboard. Onto the ProClip you can install e.g. a holder for your mobile phone or PDA or a handsfree set etc. Safe and convenient -always within easy reach. The ProClip is car specific and easy to install. The installation is quick, no special tools or dismantle of the dashboard is required and it will not damage the interior of the vehicle. Made in black ABS plastic. Comes with detailed instructions. Angled mount, Low Please read all of the instructions and look at the pictures before attaching the ProClip.

1. Press the thin end of the enclosed gap opener into the gap between the padded console edge and the center console panel, to widen the gap. Peel off the cover of the adhesive tape on the ProClip.

2. Press the curved edge on the right side of the ProClip into the gap below the gap opener. Make sure you also get the lower part of the angled edge into the gap.

3. Press firmly forward on the left side of the ProClip so the angled edge hooks over the console edge. Press the ProClip towards the sidewall to make sure the angled edge hooked properly over the console edge. Pull out the gap opener.

4. The ProClip is in place.