The ProClip is a mounting bracket for the vehicle's dashboard. Onto the ProClip you can install e.g. a holder for your mobile phone or PDA or a handsfree set etc. Safe and convenient -always within easy reach. The ProClip is car specific and easy to install. The installation is quick, no special tools or dismantle of the dashboard is required and it will not damage the interior of the vehicle. Made in black ABS plastic. Comes with detailed instructions. Angled mount, NOT for dash with navigation. Please read all of the instructions and look at the pictures before attaching the ProClip.
This ProClip consists of two parts.
Part 1. Attaching part (the smallest part)
Part 2. ProClip face plate.
1. Press the thin end of the two enclosed gap openers into the gap between the center console panel frame and the padded console edge, to widen the gap. Peel off the cover of the adhesive tape on Part 1. Place Part 1 in the same position as in the picture, in the same height. Place the angled edge of Part 1 against the gap between the gap openers.
2. Press the angled edge firmly into the gap and at the same time bend Part 1 to the left until you hear/feel it snaps into place and the adhesive tape attaches to the console edge. Pull out the gap openers.
3. Press a screwdriver (Philips) firmly through the predrilled holes in Part 2 to open them up. Peel off the cover of the adhesive tape on Part 2. Place Part 2 onto Part 1 so the holes match and the adhesive tape on Part 2 is on the right side attaching to the center console panel frame. Screw Part 2 onto Part 1 using the enclosed screws. Screw straight into Part 1, in the same angle as Part 1.
4. The ProClip is in place.
