The ProClip is a mounting bracket for the vehicles dashboard. Onto the ProClip you can install e.g. a holder for your mobile phone or PDA or a handsfree set etc. Safe and convenient -always within easy reach. The ProClip is car specific and easy to install. The installation is quick, no special tools or dismantle of the dashboard is required and it will not damage the interior of the vehicle. Made in black ABS plastic. Comes with detailed instructions. Center mount Please read all of the instructions and look at the pictures before attaching the ProClip.
This ProClip consists of two parts.
Part 1. Attaching part (the smallest part)
Part 2. ProClip face plate
1. Peel off the adhesive tape cover on Part 1. Press the thin end of the enclosed gap opener into the gap between the frame surrounding the air vent and the control panel, to widen the gap. Prize the gap wider with the gap opener, in the same time press the angled edge on Part 1 into the gap above the gap opener. Press Part 1 rightwards so the angled edge hooks behind the control panel. Pull out the gap opener.
2. Open up the predrilled holes in Part 2 with a screwdriver (Philips). Press the gap opener into the gap in the dashboard overhang. Prize the gap wider with the gap opener, in the same time press the grooved edge on Part 2 into the gap next to the gap opener. Start by pressing the right corner of the grooved edge into the gap, then follow through and press all the edge into the gap. Pull out the gap opener. Slide Part 2 sideway so the holes match with the holes in Part 1.
3. Screw Part 2 onto Part 1 with the enclosed screws.
4. The ProClip is in place.