技术细节
| 最大传输距离 |
91.44 m |
| 可支持的电缆类型 |
Cat5e, Cat6 |
| 类型 |
AV receiver |
端口 & 界面
| 串口数量 |
1 |
| RJ-45输出端口 |
1 |
| HDMI输入 |
1 |
300 ft, 1080p, HDMI/RS232, Cat5e/Cat6, White
The TruLink HDMI+RS232 over Cat5 allows you to extend HDMI and Serial RS232 signals over a single Cat5/Cat5e/Cat6 unshielded twisted pair cables up to 300ft without signal degradation at 1920x1200 or 1920x1080 resolutions*. This solution is compatible with any operating system and is truly plug and play with no drivers or software required. The transmitter and receiver come in either wall plate or box form factors and are interoperable allowing a choice in the form factors that are best suited for the application. In addition, this solution utilizes TruChoice™ power providing the flexibility to power at either the transmitter or receiver end. HDBaseT technology allows the Extended Display Identification Data (EDID) signals, i.e. communication of the display?s capabilities, to pass through the extension solution ensuring that the content from the source is sent at the optimal resolution for the display. Built-In power surge protection and high ground loop immunity ensure high performance signal extension.
The RS232 serial port supports full-duplex data communication at 230Kbps and is fully compatible with all RS232 protocols. Point-to-point or multi-drop data communication is supported.
*Longer extension distances may be achieved at a lower video resolution.
Note: Stranded Cat5e/6 cables may be used for HDMI extension applications up to 250ft. Shielded, solid conductor Cat5e/6 cabling is recommended for applications where the Cat5e/6 cable must be coiled, is run near other high-frequency signaling cables or in high EMI/RFI environments.
- Input: (1) HDMI Female , (1) DB9 Male
- Output: (1) RJ-45 Female
