性能
支持以太网(PoE) |
Y |
全双工传输 |
Y |
类型 |
Network transmitter & receiver |
可支持的电缆类型 |
Cat5e, Cat6 |
数据传输速度 |
1000 Mbit/s |
最大传输距离 |
360 m |
OutReach Killer - Gigabit Ethernet, 1000Mbps Full-duplex, PoE 802.3af / PoE+ (802.3at)
- Extends standard Gigabit Ethernet Full Duplex 6 times beyond the IEEE barrier of 328ft or 100m with PoE+ 56V over CAT5e/6
- Three port design allows for deployment of (2) separate PoE IP Cameras or devices up to 1,200ft/360m
- DIP switch selection enables you to turn on or off the PoE output for each port.
- Rapid LAN style installation RJ45 LAN Interfaces - no programming required.
- Cisco / Motorola reverse polarity PoE compatible
- Daisy chain up to (2) 828’s to 360m or 1,200ft
- Ideal for deploying High Def IP Cameras requiring Gigabit throughput at distance.
- Supports VoIP (Voice over IP).
- Network Equipment independence - Transparent to protocols, applications and MAC addresses.
- Sustained full-duplex service delivery end to end.
- You supply the PoE or can be used Enable-IT 360 PoE+ 50W-60V Injector.
The Enable-IT™ 828 Gigabit Ethernet Extension Unit is the world’s First copper Gigabit solution in the industry today. This unit is a standalone kit and can be used without the power adapter with your PoE Injector or PoE Midspan. The standalone 828 can drive incremental Gigabit Ethernet to 240m or 800ft. This cost effective unit blows away any previous solution including fiber for very quick plug and go installation of PoE IP cameras, PoE Access Points and remote LAN segments.
The Enable-IT 828 can drive industry standard Gigabit Ethernet signals to over six times the restricted IEEE standard Ethernet distance when combined in a series of multiple units and uses high power PoE+. This cost-effective solution eliminates many of the limitations and high costs for extending LAN cabling today.
The 828 Series Solution is a standalone powered Gigabit Ethernet Repeater that doubles the range of your Gigabit Ethernet to an unpowered remote location. This is ideal for installing high powered PoE+ cameras remotely using only a CAT5e or CAT6 rated 100m cabling. Selectable DIP switches allow for disabling PoE output on either ouytput port to enable standard non PoE LAN devices such as a laptop to configure an IP camera. You can also daisy chain (2) 828 units to reach 360m / 1,200ft to power a 48v PoE device easily.