端口 & 界面
VGA(D-SUB)输出端口 |
3 |
RJ-45输入端口 |
2 |
RJ-45输出端口 |
2 |
VGA(D-SUB)输入端口 |
1 |
DC-IN插口 |
Y |
技术细节
最大传输距离 |
100 m |
类型 |
AV transmitter & receiver |
可支持的电缆类型 |
Cat5 |
音频系统 |
stereo |
Extender, CAT5, 1920x1200, 100m, Horizontal Frequency Range: 15 - 70kHz, Vertical Frequency Range: 30 - 170Hz, Video Amplifier Bandwidth: 350MHz, 1x VGA In (Sender), 1x VGA Out (Sender), 2x VGA Out (Receiver), 3.5mm Audio In, 3.5mm Audio Out, 1x USB B (Sender), 4x USB A (Receiver)
<b>Extends VGA, audio, and USB 2.0 up to 330 feet (100 meters) over two CAT-5 cables</b>
The Gefen CAT5-1600A extends VGA, Audio, and USB up to 330 feet (100 meters) using CAT-5 cables. Display resolutions up to 1920x1200 are supported. A local monitor can be connected to the Sender unit and up to two monitors can be connected to the Receiver unit. Four USB connectors on the Receiver unit allow control of the computer system from a KVM workstation. Mini-stereo connectors extend analog audio. A Power-saving "Green Mode" can be set via DIP switches on the Sender and Receiver. When activated, both units will go into low-power Standby Mode when the Sender's VGA input signal disappears.
<b>How It Works</b>
Place the CAT5-1600A Sender unit next to the VGA source. Use the included VGA cable to connect the source to the Sender unit. Optionally connect a local monitor to the Sender unit using a VGA cable. Connect up to two monitors to the Receiver unit with VGA cables. Connect the USB devices to the input and output connectors. For audio, connect a mini-stereo cable between the audio source and the audio input on the Sender unit. Connect a mini-stereo cable between the audio output on the Receiver unit and the audio device. Use two CAT-5 cables to connect the Sender unit to the Receiver unit.
Connect the included locking power supplies to both the Sender unit and Receiver unit then connect both power cables to available electrical outlets. The computer can now be controlled from the KVM workstation.