音频
| 最大输入水平 |
5 V |
| 频率范围 |
15 - 70000 Hz |
输出
| 分量视频(YPbPr/YCbCr)输出 |
1 |
| Line-out |
Y |
输入
| PC机(D型接口) |
N |
| PC音频 |
N |
| Line-in |
Y |
| 分量视频(YPbPr/YCbCr)输入 |
1 |
另外
| 以太网路(RJ-45)连接接口数量 |
1 |
| 连接方式 |
Wired |
Sender Unit, 1080p, 1:8 Component/Audio, 1 x YPrPb In, 8 x RJ-45 Outputs, CAT5, 1000ft
Extend Component Video and Audio to 8 Remote Locations
The 1:8 Component/Audio over CAT5 Distribution Amplifier sends up to 8 identical sets of sparkling clear component video with audio to remote locations via eight CAT5 cables at distances of up to 1000 feet. Now you can reliably and cleanly distribute up to eight copies of a video signal and digital or analog audio to remote locations without having to worry about signal drop-off and loss of quality.
How It Works
Simply plug in your component video and audio from your source to the 1:8 Component/Audio D.A. Sender. Your audio can be analog, SPDIF or TOSlink. Run your CAT5 cables from the Sender box to up to 8 remote destinations, then connect a Receiver box (sold separately) to each CAT5 cable at the terminating end. Attach the Receivers to your displays, turn on all equipment, and you should see beautiful video. All audio ports on the receiver will also be active, so even if your source only had analog audio your Component Audio Receiver will have digital and analog audio output. The sender and receiver both will be powered individually by 5V power supplies.
Note: 1 Component Audio CAT5 Receiver is needed for each remote location (Sold separately).
