Kurth Electronic CCTS-02 Black

Kurth Electronic CCTS-02 Black

MPN: 0.49616
发送方式:
交货来源:
德国
更新价格... 📣 询问价格 Не поставляется
运输成本:
От

凡购买和价格 (Advertising *)

顶部
в наличии
* Alle Preise inkl. der jeweils geltenden gesetzlichen Mehrwertsteuer, ggfs. zzgl. Versandkosten. Alle Angaben ohne Gewähr. Preisänderungen sind in der Zwischenzeit möglich.

技术特点

顶部
CCTS-02 Cable Conductor Test Set - indispensable for fault tracking, maintainance, setup
- useful also on powerde telecom lines
- line resistance up to 2000 Ohm
- Microprocessor for tuning on life lines
- xDSL and Data safe
- over voltage protected

CCTS02 cable conductor test set is used in a set of two. Two (or more) technicians are able to setup a communications path over dead lines up to 3000 Ohms or more. Be carefull - only on dry telephone lines it is possible to setup communications. Don`t use it on life power lines.

After a new cable installation or after repair a cable in service, the cable has to be tested for common faults like pair reversals, opens, shorts or ground faults.
These tests are fast and easy to handle with CCTS02.

To establish voice communication over a dead pair, plug the headset into the jack on the left side. Turn CCTS02 on. The red ON LED indicates that the unit is on. Connect the black talk leads to a empty pair on the cable. There is no special polarity. If both units are connected to the same pair, voice communication is established. To test wires, one unit has to be in RX-mode and one in TX-mode.
The test tone is audible in both headsets when the red test lead is in contact with the same conductor under test.

If the pair is in service, it is sometimes, especially if xDSL or ISDN service is on the line, impossible to find a single wire Tip (A) or Ring (B). This because the impedance between the wires of a pair is very low ( i.e. 120 Ohms). CCTS02 Microprocessor technology tunes the unit to the resistance of one wire. After it is possible to find wires with low resistance differences to the corresponding wire in a pair.
This saves time - no need for open the line on the MDF.

The electronic circuits are protected by a solid housing made of ABS. To protect the units they are stored in a pouch of strong cordura. The battery compartment is separated and closed by captive screws. CCTS02 needs a standart 9 Volt alkaline battery.

CCTS02 comes with solid test leads with 4mm banana plugs, solid clips and test tip. There is a lightweight and noise compensated headset and a special headset to use in conjunction with a hard hat.
Фотографии

    密码恢复
    要恢复您的密码,请在下面您的电子邮件地址框与您已注册请输入:
    The password reset code has been sent to your Email.
    Код уже был отправлен Вам ранее.
    Вы можете ввести его в поле выше, или получить новый код через сек.
    发生了错误。请检查您的电子邮件地址,然后再试一次。
    Ваш новый пароль:

    名称为空


    Выберите страну доставки

    您还没有写消息

    By clicking on the "Send" button, you agree that your data will be used to process your request. Further information and revocation instructions can be found in the data protection declaration.

    已发送您的消息!

    親密

    1
    产品目录
    取消
    Бренды:
      Выберите бренды
        查看更多
          地區搜索
          全球
          Категории
            产品名称