能量控制
| 输入电压 |
100 - 240 V |
| 接受频率 |
50/60 Hz |
| 支持以太网（PoE）电源供应 |
52 V |
| 功耗（最大） |
30 W |
| 输入电流 |
0.8 A |
| 输出电流 |
0.6 A |
| 输出功率 |
30 W |
联网
| 以太网的数据传输率 |
10, 100, 1000 Mbit/s |
| 以太网接口类型 |
Gigabit Ethernet |
| 支持以太网（PoE） |
Y |
重量和尺寸
| 尺寸（宽 x 深 x 高） |
87.9 x 51.3 x 166 mm |
| 包装长度 |
125 mm |
| 重量 |
350 g |
| 包装盒宽度 |
210 mm |
| 包装盒高度 |
55 mm |
环境条件
| 储存温度范围 (T-T) |
0 - 70 °C |
| 储存相对湿度范围（H - H） |
5 - 95% |
| 运行湿度范围(H-H) |
5 - 95% |
产品特点
| 液晶显示器指示灯 |
PoE, Power |
| 认证 |
FCC Part 15, CE, RoHS |
| 最高操作距离 |
100 m |
另外
| 产品色彩 |
Black |
| 以太网路(RJ-45)连接接口数量 |
2 |
| 运行温度范围（T - T） |
0 - 45 °C |
2 x 10/100/1000Base-T RJ-45, PoE 52V, 30W, 100-240VAC, IEEE 802.3/u/ab/af
The LevelOne POI-3004 is a Power over Ethernet (PoE) injector that not only delivers a cost-effective solution for power distribution, but also provides a seamless way of deploying Powered Devices (PDs) on existing LAN infrastructure.
With the use of power injectors, DC power of up to 30W and the data that comes from a non-PoE switch are merged together and then transmitted to a PD such as a PoE network camera, through the Ethernet cabling. This allows you to extend the use of your existing hardware investment without needing to buy extra PoE switches.
Furthermore, non-PoE devices like wireless access points can also be powered up remotely by adding additional PoE splitters, since power and data are further split into two cables. These devices can therefore be installed in hard-to-reach areas like ceilings where there are no outlets or electrical wiring nearby.
- PoE supplies up to 30W of power feeding on 2 pairs
- Remove the need for a bulky power adapter and power line
- Delivers power and data to equipment via a single Ethernet cable
- Remote power feeding up to 100m
- Unique interlocking feature for easy installation
- Surge protected to enhance safety
- Simple Plug and Play installation
- Compact, lightweight design
