Marmitek TM13 Transceiver Module - Converts radio signals of Marmitek Remote Controls, Wireless Switches and Wireless Sensors to the Marmitek X-10 Protocol on the mains.
The TM13 Transceiver Module is the central receiver necessary when using
Marmitek Wireless Remote Controls, Wireless Switches and Wireless Sensors.
The TM13 Transceiver converts the signals from these devices to the Marmitek
X-10 Protocol on the mains, so that all Marmitek X-10 Modules can be controlled
via the mains.
The Transceiver Modules contains a selector switch for the House Code. The House
Code of the TM13, the modules and remote controls have to be set to the same
letter code to be able to control up to 16 Marmitek X-10 modules. Position “P”
will transmit all house codes.
The built-in appliance module can be switched with a command via a wireless
controller, such as a radio remote control, or via the mains using the Marmitek
X-10 protocol. The built-in appliance module always responds to Unit Code 1.
When the Transceiver Module is combined with the CM11 Computer interface,
the TM13 functions as a ‘gateway’ to transmit signals from e.g. remote controls to the CM11. Using the TM13, any macros stored in the CM11 Computer Interface
can be activated using a wireless remote control and all Marmitek X-10 addresses
can be controlled (max. 256 modules).
The Transceiver Module has a plug and switched socket and can be connected without extra wiring.
Reading the status of the TM13 is possible with the use of the CM11 computer interface.
