技术细节
串口数量 |
1 |
隔离度 |
1.5 kV |
以太网的数据传输率 |
10, 100 Mbit/s |
波特率 |
921.6 Kbit/s |
浪涌保护 |
2 kV |
停止位 |
2, 1.5, 1 |
流量控制支持 |
Y |
静电放电(ESD)保护装置 |
8 kV |
自动 MDI / MDI - X 检测功能 |
Y |
能量控制
耗电量 |
180 mA |
输入电压 |
12 - 48 V |
设计
安全 |
UL 60950-1 |
静电放电(ESD)保护装置(接触) |
4 kV |
Electrostatic Discharge (ESD) protection (air) |
8 kV |
协议
支持网络协议 |
ICMP, IPv4, TCP, UDP, DHCP, BOOTP, Telnet, DNS, SNMP V1, HTTP, SMTP, IGMP V1/2, ARP |
1-port RS-232/422/485 PoE device server, -40 to 75°C
NPort® P5150A device servers are designed to make serial devices network-ready in an instant. It is a PD device and is IEEE 802.3af compliant, so it can by powered by a PoE PSE device without an additional power supply. Use the NPort® P5150A device servers to give your PC software direct access to serial devices from anywhere on the network. The NPort® P5150A device servers are ultra lean, ruggedized, and user friendly, making simple and reliable serial to Ethernet solutions possible.
<b>Surge-protected Serial, Ethernet, and Power Lines </b>
Surge, which is typically caused by high voltages that result from switching and lightning transients, is a common threat to all electrical devices. Moxa’s leading-edge surge immunity solution, which is applied to the NPort® P5150A’s serial, power, and Ethernet lines, is tested and proven compliant with IEC 61000-4-5. This state-of-the-art surge protection provides a robust serial-to-Ethernet solution that can protect electrical devices from voltage spikes and withstand electrically noisy environmental conditions.
<b>3-step Web-based Configuration</b>
The NPort® P5150A’s 3-step web-based configuration tool is straightforward and user-friendly. The NPort® P5150A’s web console guides users through 3 simple configuration steps that are necessary to activate the serial-to-Ethernet application. With this speedy 3-step web-based configuration, a user only needs to spend an average of 30 seconds to complete the NPort® settings and enable the application, saving a great amount of time and effort.
<b>Easy to Troubleshoot</b>
NPort® P5150A device servers support SNMP, which can be used to monitor all units over Ethernet. Each unit can be configured to send trap messages automatically to the SNMP manager when user-defined errors are encountered. For users who do not use SNMP manager, an e-mail alert can be sent instead. Users can define the trigger for the alerts using Moxa’s Windows utility, or the web console. For example, alerts can be triggered by a warm start, a cold start, or a password change.