CK-300 - 25 mb, USB 2.0, Black
Nokia Car Kit CK-300 support
Keep your Nokia Car Kit CK-300 software up-to-date!
The software of your Nokia Car Kit CK-300 can be updated by contacting your local installer or Nokia Care point.
Instructions for installers and customer care points
It is recommended to use a Windows PC and Nokia USB cable CA-138D. The software update tool will update your Nokia Car Kit CK-300 with the latest available software.
Nokia USB cable CA-138D is available through the Nokia Official Mobile Enhancements Partner, Nokia Care point, installers and distributors.
Instructions for updating the software:
- Download Nokia Car Kit Software Updater tool and save it to your computer;
- Install Nokia Car Kit Software Updater. The wizard will install the tool and the Nokia USB cable driver if needed. Accept installation of drivers (if such warnings appear;
- Launch Nokia Car Kit Software Updater, click on the arrow to start the update, and follow instructions;
- If Internet connection is permanently available, then select Download software and update device. Otherwise, you may firstly to download a new software by Download software only, and than when Internet is not available to update device by Update device with local software;
- Connect the Nokia USB cable CA-138D to the Nokia HW-21W (hands free unit) and start the ignition on your car;
- Nokia Car Kit Software Updater will check for new updates on the Nokia Firmware Server. This can take several minutes, which depends on speed of Internet connection you have;
- Accept the license agreement and the firmware will start reflashing of the device;
- You can be prompted again to accept installation and use of a driver;
- Wait for the new software to be updated. Enjoy your updated Car Kit.
Important:
- If you do not have a USB driver for CK-300 installed (for instance you declined installation of drivers when it was prompted), install it following the instructions at the bottom of this page.
- In case of failure during software update (for instance cable got disconnected) you may need to reset power of the device (switch power off/on).
