StarTech.com VGA Wall Plate Video Extender Receiver over Cat 5 with Audio

StarTech.com VGA Wall Plate Video Extender Receiver over Cat 5 with Audio Extend and distribute a VGA signal to a remote display over Cat5 cabling – receiver only<br/><br/>This CAT5 VGA Extender (Receiver) Audio/Video Wall Plate can be used with StarTech.com's UTPEA VGA with Audio extender system, allowing in-wall connections from a VGA video and audio source to a remote location up to 300m (950ft) away.<br/><br/>Both VGA transmitter and receiver units use a 12V DC terminal block connector behind the unit that offers a more secure and economical installation; using Cat5/Cat6 cable to extend the VGA signal offers a cost-effective solution based on the broad availability of networking cable which is far more flexible than VGA cable, not to mention less expensive.<br/><br/>Unlike some video extension systems, our VGA extender wall plates also allow you to make use of an existing networking cable (Cat5, Cat6) infrastructure, eliminating the need to re-run cable in the event of an upgrade from VGA to another video standard, by simply swapping out the wall plates.<br/><br/>The StarTech.com Advantage<br/><br/>- Integrators and installers now have the choice of bulk rolls for custom length on field termination or using set lengths for quicker installs.<br/>- Since STUTPRXWLA is compatible with the UTPEA Series, you can keep your existing VGA video transmitter extenders (ST124UTPEA and ST128UTPEA) and add or switch to a wall plate VGA video extender receiver.<br/>- The STUTPRXWLA uses Cat5 cabling because it is lightweight, flexible, fits through small conduits.<br/>- Use existing in-wall Cat5 cabling and save time for installations. Simply plug in the Cat5 cable into the RJ-45 connector and the cable is locked in.