Transition Networks C4TEF1014-100 Internal 155Mbit/s 1310nm Single-mode network media converter

1310 nm, single mode, SC to 4x RJ-48 + 6-pin DIN These products offer a low cost transport capability for four T1/E1 and one RS232 data channel line. The converters provide copper connections compatible with G.703 and AMI/B8ZS/HDB3; while the optical connection will run at 155Mbps. A hardware-based solution guarantees the constant bit rate of TDM transport without requiring traffic management. The product provides physical layer status monitoring and alarm classification functions for Telecom operators to manage their fiber optic network and reduce operation and maintenance costs. Target applications of the converter include: FTTx, such as Fiber-to-the-Business, Fiber-to-the-Building, Fiber-to-the-MDU and Fiber-to-the-Home.

- Remote Management
- Local and Remote Loopback - This feature puts a converter in a special mode that enables the device to loop back the signal from the RX port to the TX port on either media for testing and troubleshooting purposes.
- AIS/TAOS
- LEDs for each data port
- DIP switches for line code, line length, local loopback or remote loopback
- T1/E1 mode switch
- Dry Relay Contacts on each TDM port
- Mirror Port (SNMP selectable)
- Local (AUX) Management Interface (RS232 connector)
- Switch selection for Data or Management mode on RS232 interface
- Password protection
- Access to complete status information on local and remote device
- Access to local and remote configuration
- Switch or SNMP selected Baud rate operation
<b>- SNMP Management Features:</b>

-
<b>Report local converter status:</b>
- Fiber Link Status
- Copper Link Status for each T1/E1
- Hardware switch settings: LBO, AIS on C/F, HW/SW, speed
- AIS detected Fiber & Copper
- Model Number
- Copper & Fiber Connectors

-
<b>Local command operations include:</b>
- Loopback Fiber & T1/E1 per channel
- AIS TX on fiber on loss of copper link & AIS TX on copper on loss of fiber link
- Serial connection speed and parity (Software Mode)
- T1/E1 Mirror Port Modes (Port Trapping)
- Boot-load firmware upgrades

-
<b>Remote converter status:</b>
- Fiber Link status
- Copper Link Status for each T1/E1
- Hardware switch settings: LBO, AIS on C/F, HW/SW, speed
- AIS detected Fiber & Copper
- Model Number
- Copper & Fiber Connectors

-
<b>Remote Commands:</b>
- Loopback Fiber & T1/E1 per channel
- Serial connection speed and parity (Software Mode)
- AIS TX on fiber on loss of copper link & AIS TX on copper on loss of fiber link