性能
波长 |
1550 nm |
灵敏度 |
-33 dBmW |
发射功率(最小) |
-8 dBmW |
最大传输距离 |
40000 m |
光纤模式结构 |
Single-mode |
发射功率(最大) |
-3 dBmW |
联网
以太网的数据传输率 |
10, 100 Mbit/s |
以太网铜缆技术 |
100BASE-TX |
另外
以太网路(RJ-45)连接接口数量 |
1 |
连接方式 |
Wired |
数据传输率(最大) |
100 Mbit/s |
100BASE-TX (RJ-45) [100 m/328 ft.], 100BASE-FX 1310nm TX/1550nm RX single fiber single mode (SC) [40 km/24.9 mi, North America
- Operates under heavy traffic loads without excess heat, so there is no need for a failure-prone internal fan.
- Round trip delay of only 40 bit times—far below the Class II rating of 92 bit times.
- Auto-Negotiation (802.3u)
Allows devices to perform automatic configuration to achieve the best possible mode of operation over a link.
- AutoCross™
Automatically detects and configures the twisted pair port on the converter to the correct MDI or MDI-X configuration.
- Link Pass Through
Link Pass Through is a troubleshooting feature that allows the media converter to monitor both the fiber and copper RX ports for loss of signal.
- Far End Fault (FEF)
A troubleshooting feature that is generally used in conjunction with Link Pass Through to notify both end devices of a loss of link.
- Automatic Link Restoration
Transition Networks's converters will automatically re-establish link in all network conditions.
- Pause (IEEE 802.3xy)
Pause signaling is an IEEE feature that temporarily suspends data transmission between two devices in the event that one of the devices becomes overwhelmed.
- The converters will also automatically re-establish link when connected to two 10/100 auto-negotiating switches if link is lost. With other manufacturers' converters the user must intervene to re-establish link.