性能
波长 |
1310 nm |
最大传输距离 |
40000 m |
光纤模式结构 |
Single-mode |
联网
以太网的数据传输率 |
10, 100 Mbit/s |
以太网铜缆技术 |
100BASE-TX |
另外
以太网路(RJ-45)连接接口数量 |
1 |
连接方式 |
Wired |
数据传输率(最大) |
100 Mbit/s |
100BASE-TX (RJ-45) 328 ft, 100BASE-FX 1550nm TX/1310nm RX single fiber single mode (SC) 24.9 mi, North America
- Operates under heavy traffic loads without excess heat, so there is no need for a failure-prone internal fan.
- Round trip delay of only 40 bit times—far below the Class II rating of 92 bit times.
- Auto-Negotiation (802.3u)
- Allows devices to perform automatic configuration to achieve the best possible mode of operation over a link.
- AutoCross™
- Automatically detects and configures the twisted pair port on the converter to the correct MDI or MDI-X configuration.
- Link Pass Through
- Link Pass Through is a troubleshooting feature that allows the media converter to monitor both the fiber and copper RX ports for loss of signal.
- Far End Fault (FEF)
- A troubleshooting feature that is generally used in conjunction with Link Pass Through to notify both end devices of a loss of link.
- Automatic Link Restoration
- Transition Networks's converters will automatically re-establish link in all network conditions.
- Pause (IEEE 802.3xy)
- Pause signaling is an IEEE feature that temporarily suspends data transmission between two devices in the event that one of the devices becomes overwhelmed.
- The converters will also automatically re-establish link when connected to two 10/100 auto-negotiating switches if link is lost. With other manufacturers' converters the user must intervene to re-establish link.