技术细节
| 传输距离（单模式） |
40 km |
| 主机接口 |
RS-232 |
| 输出接口 |
Fiber (SC) |
| 波特率 |
115 Kbit/s |
| 波长 |
1550 nm |
| 接收器灵敏度 |
-33 dB |
| 串口数量 |
1 |
RS232 Media Converter, DB-9 [15 m/49 ft.], 1310nm TX/1550nm RX single fiber single mode (SC) [40 km/24.9 mi.]
Transition Networks's serial RS232 to Fiber Media Converter allows you to extend the distance between serial connections with the use of fiber optic cable. This full-featured converter transmits the full complement of RS232 flow control/handshaking signals optically and supports full or half-duplex asynchronous data transmission at speeds up to 115Kb/s.
The diagnostic features included on this converter make installation easy and intuitive. A DTE/DCE switch eliminates the frustration over selecting the appropriate cable. A loop-back switch allows for complete diagnostic testing prior to system turn-up or during troubleshooting. Unit and Port LEDs allow for quick status information of the converter.
In addition to status LEDs and switch settings for local management, these converters can also be managed from remote locations when used in conjunction with a managed Point System™ chassis.
- Remote management
- Loopback (Local or Remote on copper and fiber)
This feature puts a converter in a special mode that enables the device to loop back the signal from the RX port to the TX port on either media for testing and troubleshooting purposes.
- DTE/DCE switch for easy installation with straight-through cabling
- Full/Half-duplex asynchronous transmission at speeds up to 115Kb/s
