产品特点
| Conductor area (min) |
0.08 mm² |
| Conductor area (max) |
2.5 mm² |
| Strip length (max) |
9 mm |
| Fire load |
0.477 MJ |
| Vibration resistant |
Y |
| AWG 美国线规导线直径（最大值） |
14 |
| Shock resistant |
Y |
| AWG 美国线规导线直径（最小值） |
28 |
| 频道/通道 数量 |
2 channels |
| 隔离度 |
0.5 kV |
| Wire clamp type |
Cage clamp |
其他功能
| 信号方向 |
Input |
| 电压 |
24 V |
| 耗电量 |
30 mA |
<b>2-channel vibration velocity/bearing condition monitoring VIB I/O </b>
The VIB I/O modules are used for online monitoring of the machine vibration level. It records the two most important parameters required for the condition analysis; vibration severity and roller bearing condition.
The severity of vibration is a measurement of the machine vibration energy and therefore, a suitable indicator for the vibration forces acting on the machine. The ISO 10816-3 standard is used to assess the results in which the effective values of the (measured) vibration are divided into three quality categories.
The roller bearing condition is evaluated on the basis of high-frequency shock impulse signals. Shock impulses are momentary impulses arising from mechanical damage to roller bearings or the bearing surfaces.
Evaluation uses a scale where the measured shock impulses are divided into three bearing condition categories: 'good', 'limited' and 'poor'. By recording the measurement results and evaluation in a trend curve, bearing damage can be detected at an early stage.
A special Tandem-Piezo® acceleration sensor at the same time, provides the measurement of machine vibrations and high-frequency shock impulse signals.
