The ProClip is a mounting bracket for the vehicles dashboard. Onto the Proclip you can install e.g. a holder for your mobile phone or PDA or a handsfree set etc. Safe and convenient -always within easy reach. The ProClip is car specific and easy to install. The installation is quick, no special tools or dismantle of the dashboard is required and it will not damage the interior of the vehicle. Made in black ABS plastic. Comes with detailed instructions. Center mount Attention: Please read all of the instructions and look at the pictures before attaching the ProClip.
1. Press the thin end of the enclosed gap opener into the gap between the air vent panel frame and the padded dashboard to widen the gap. (Note: You can attach the ProClip anywhere within the width of the air vent) Clean the wood grain ledge with the enclosed alcohol pad and peel off the cover of adhesive tape on the ProClip.
2. Press the grooved edge on the upper part of the ProClip into the gap next to the gap opener. Press until you see or hear/feel it snap into place. (Make sure the adhesive tape on the lower part of the ProClip does not attach to the wood grain ledge, yet.)
3. Place the edge of the lower part of the ProClip up against the padding below the air vent and then press down on the inside of the ProClip towards the ledge so the adhesive tape attaches properly. Pull out the gap opener.
4. The ProClip is in place.
