NOT for model with built-in monitor in headrest. For Apple iPad. The choice for you who use your iPad in the back seat of a car. The iPad mount is placed onto a front seat's headrest. The installation is quick and easy, no special tools are required and the interior will not be damaged. You can connect e.g. a charging cable to the iPad when it is in the holder.
The mount is equipped with a tilt swivel. This mean that you can adjust the angle in order to avoid light reflection on the screen. You can easily switch between portrait and landscape mode by turning the holder into desired position. It is easy to put the iPad into place in the holder, and to take it with you when leaving the car. . Please read all of the instructions and look at the pictures before attaching the headrest mount.
1. Place the back part of the headrest mount behind the headrest. Place the front part of the headrest mount on the other side so you have one part on each side of the headrest.
2. Put the enclosed screws into place in the front part of the headrest mount. Tighten the screws with the enclosed tool. Screw until the headrest mount is properly in place. Place the attaching plate on desired position. Screw the attaching plate into place with the enclosed screws.
3. To place the device in the holder: Place the lower part of the device in the holder, then flip/press the upper part forwards so it snaps into place in the holder. To remove the device from the holder: Press upwards on the upper part of the holder, in the same time pull the upper part of the device out from the holder and then lift the device up and out from the holder.
4. The headrest mount is in place.
