With flexible arm. The choice for you who use your iPad in the back seat of a car. The iPad mount is placed onto a front seats head rest and has a flexible arm so you can adjust the screen just the way you want. You can connect e.g. a charging cable to the iPad when it is in the holder.
You can easily switch between portrait and landscape mode by turning the holder into desired position. It is easy to put the iPad into place in the holder, and to take it with you when leaving the car. The installation is quick and easy, no special tools are required and the interior will not be damaged. The length of the flexible arm is 27 cm.
The headrest mount fits a number of vehicles. Measure the headrest in you vehicle. If the following specifications match your measurements, this product will fit your vehicle:
Minimum inner distance between the headrest bars: 95 mm
Maximum outer distance between the headrest bars: 211 mm Please read all of the instructions and look at the pictures before attaching the headrest mount.
1. Remove the two screws in the front side of the headrest mount using the enclosed tool, so you get two parts. Place one part of the headrest mount on each side of the headrest. Put back the screws and tighten them until the headrest mount is properly in place.
2. To place the device in the holder: Place the lower part of the device in the holder, then flip/press the upper part forwards so it snaps into place in the holder. To remove the device from the holder: Press upwards on the upper part of the holder, in the same time pull the upper part of the device out from the holder and then lift the device up and out from the holder.
3. Switch between portrait and landscape mode by turning the holder.
4. The headrest mount is in place.
