Brodit ProClip

The ProClip is a mounting bracket for the vehicle’s dashboard. Onto the Proclip you can install e.g. a holder for your mobile phone or PDA or a handsfree set etc. Safe and convenient -always within easy reach. The ProClip is car specific and easy to install. The installation is quick, no special tools or dismantle of the dashboard is required and it will not damage the interior of the vehicle. Made in black ABS plastic. Comes with detailed instructions. Center mount Attention! Please read all of the instructions and look at the pictures before attaching the ProClip. Note: This ProClip can be attached within the width of the air vent.

1. Peel off both adhesive tape covers on the ProClip. Choose location for the ProClip within the range of the width of the air vent. Place the ProClip over the air vent at the selected position. Press the thin end of the two enclosed gap openers into the gap, one on each side of the ProClip, between the padded part of the dashboard and the center console panel to widen the gap.

2. Press the thin end of the lower part of the ProClip all the way into the gap between the gap openers. Pull out the gap openers.

3. Press the grooved edge on the upper part of the ProClip into the gap between the air vent frame and the padded dashboard. Press until you see or hear/feel it snaps into place. (Note: if the gap is very tight, press the thin end of the two enclosed gap openers into the gap, one on each side of the ProClip, to widen the gap. Then press the ProClip into the gap)

4. The ProClip is in place.