Brodit ProClip

The ProClip is a mounting bracket for the vehicle’s dashboard. Onto the Proclip you can install e.g. a holder for your mobile phone or PDA or a handsfree set etc. Safe and convenient -always within easy reach. The ProClip is car specific and easy to install. The installation is quick, no special tools or dismantle of the dashboard is required and it will not damage the interior of the vehicle. Made in black ABS plastic. Comes with detailed instructions. Angled mount Attention! Read all instructions before attaching the ProClip.
This ProClip consists of two parts.
Part 1. Attaching piece
Part 2 ProClip face plate.

1. Press the thin end of the enclosed gap opener into the gap between the control panel and the dashboard to widen the gap.

2. Peel off the cover of the adhesive tape on Part 1. Press Part 1 into the gap above the gap opener. Press to the right on Part 1 so the angled edge hooks under/behind the control panel and the adhesive sticks to the dashboard. Pull out the gap opener.

3. Press a screwdriver through the predrilled holes in Part 2 to open them up. Peel off the cover of the adhesive tape. Place Part 2 onto Part 1 so the holes match. Screw Part 2 onto Part 1 using the enclosed screws. Make sure that the screws go straight into Part 1, in the same angle.

4. The ProClip is in place.