The ProClip is a mounting bracket for the vehicles dashboard. Onto the Proclip you can install e.g. a holder for your mobile phone or PDA or a handsfree set etc. Safe and convenient -always within easy reach. The ProClip is car specific and easy to install. The installation is quick, no special tools or dismantle of the dashboard is required and it will not damage the interior of the vehicle. Made in black ABS plastic. Comes with detailed instructions. Angled mount Attention! Read all instructions before attaching the ProClip
This ProClip is divided into two parts, which will be referred to as Part 1, and Part 2:
Part 1: The attaching part (the smallest part)
Part 2: The ProClip faceplate
1. Press a screwdriver (Philips) firmly through the predrilled holes in Part 2 to open them up. Press the angled edge on the left side of Part 2 into the gap between the stereo and the surrounding panel frame.
2. Peel off the cover of the adhesive tape on Part 1. Pull Part 2 a little towards you and place Part 1 behind Part 2. Press the thin angled edge on Part 1 into the gap between the narrow wood grain panel and the center console edge. Press the angled edge firmly into the gap and bend Part 1 to the right until you hear/feel it snap into place.
3. Adjust so the holes in Part 2 match the holes in Part 1. Screw Part 2 onto Part 1 using the enclosed screws. NOTE: DON'T SCREW THE SCREWS INTO PART1 IN AN ANGLED POSITION BASED ON THE ANGLE OF PART 2, BUT STRAIGHT INTO PART 1.
4. The ProClip is in place.