The ProClip is a mounting bracket for the vehicles dashboard. Onto the Proclip you can install e.g. a holder for your mobile phone or PDA or a handsfree set etc. Safe and convenient -always within easy reach. The ProClip is car specific and easy to install. The installation is quick, no special tools or dismantle of the dashboard is required and it will not damage the interior of the vehicle. Made in black ABS plastic. Comes with detailed instructions. Center mount Attention: Please read all of the instructions and look at the pictures before attaching the ProClip.
This ProClip is divided into two parts.
Part 1: The attaching part (the smallest part)
Part 2: The ProClip faceplate
1. Press the thin end of the enclosed gap opener into the gap between the air vent panel and the instrument panel, to widen it. Peel off the cover of the adhesive tape on Part 1 and place the thin angled edge into the gap below the gap opener.
2. Press the angled edge firmly into the gap and at the same time: bend Part 1 to the right until you hear/feel it snaps into place and the adhesive tape attaches to the instrument panel frame.
3. Press a screwdriver (Philips) firmly through the holes in Part 2 to open them up. Peel off the cover of the adhesive tape on Part 2. Place Part 2 onto Part 1 so the holes match, and the adhesive tape on Part 2 is on the left side attaching to the center dashboard panel. Screw Part 2 onto Part 1 using the enclosed screws. Screw the screws almost all the way in and then adjust the ProClip leftwards, towards the instrument panel, so the adhesive tape on the right side of the ProClip doesn't attach to the stereo. Tighten the both screws.
4. The ProClip is in place.
