Brodit ProClip

The ProClip is a mounting bracket for the vehicle's dashboard. Onto the Proclip you can install e.g. a holder for your mobile phone or PDA or a handsfree set etc. Safe and convenient -always within easy reach. The ProClip is car specific and easy to install. The installation is quick, no special tools or dismantle of the dashboard is required and it will not damage the interior of the vehicle. Made in black ABS plastic. Comes with detailed instructions. Angled mount Attention! Please read all of the instructions and look at the pictures before attaching the ProClip.

1. Open the glove compartment. Place the thin end of the enclosed gap opener in the gap between the control panel frame and the dashboard, right above the gap in the control panel (see picture), then press the gap opener into the gap to widen the gap. Peel off the adhesive tape covers on the ProClip. Press the curved edge on the right part into the gap below the gap opener. Flip the ProClip leftwards so the curved right edge hooks behind the control panel frame. Pull out the gap opener.

2. Loosen the screw by the glove compartment. Press the gap opener sideways into the gap between the glove compartment and the dashboard.

3. Press/hook the long left part of the ProClip into the gap between the glove compartment and the dashboard so the angled edge hooks behind the glove compartment. Pull out the gap opener. Tighten the screw. Close the glove compartment.

4. The ProClip is in place.