Brodit ProClip

The ProClip is a mounting bracket for the vehicle’s dashboard. Onto the ProClip you can install e.g. a holder for your mobile phone or PDA or a handsfree set etc. Safe and convenient -always within easy reach. The ProClip is car specific and easy to install. The installation is quick, no special tools or dismantle of the dashboard is required and it will not damage the interior of the vehicle. Made in black ABS plastic. Comes with detailed instructions.

This ProClip fits models with and without factory navigation screen. The ProClip can be attached anywhere within the width of the air vent and you can have two ProClips attached next to each other. Center mount Please read all of the instructions and look at the pictures before attaching the ProClip. TheProClip fits models with and without factory navigation screen.

1. Use the enclsoed alcohol pad to clean the area where the ProClip is to be installed. Press the thin end of the enclosed gap opener into the gap between the dashboard ledge and the center console top, to widen the gap. Peel off the cover of adhesive tape on the ProClip. Hook the curved edge on the upper part of the ProClip into the gap next to the gap opener. Press until you see or hear/feel it click into place. Pull out the gap opener.

2. Place your fingers behind the ProClip face plate and pull towards you. The ProClip will now flex forward. Then hook the angled edge around the upper air vent edge.

3. The ProClip can be attached anywhere within the width of the air vent and you can have two ProClips attached next to each other. This instruction applies for either position.

4. The ProClip is in place.