Brodit ProClip

The ProClip is a mounting bracket for the vehicle’s dashboard. Onto the ProClip you can install e.g. a holder for your mobile phone or PDA or a handsfree set etc. Safe and convenient -always within easy reach. The ProClip is car specific and easy to install. The installation is quick, no special tools or dismantle of the dashboard is required and it will not damage the interior of the vehicle. Made in black ABS plastic. Comes with detailed instructions. Center mount, Will block heated seat switch. Please read all of the instructions and look at the pictures before attaching the ProClip.

1. Use the enclosed alcohol pad to clean the area where the ProClip is to be installed. Press the thin end of the enclosed gap opener into the gap between the frame surrounding the control panel and the panel surrounding the display, to widen the gap. Peel off the adhesive tape cover on the ProClip. Press the left corner of the upper part of the ProClip into the gap next to the gap opener.

2. Press down on the right part of the ProClip so all of the angled edge goes into the gap. Slide the ProClip leftward in the gap, as far as possible. Pull out the gap opener.

3. Press the gap opener into the gap between the control panel and the surrounding frame. Press the lower part of the ProClip forward so the thin lower edge goes into the gap next to the gap opener. Press forward on the lower part of the ProClip so the edge goes all the way into the gap. Pull out the gap opener.

4. The ProClip is in place.