The ProClip is a mounting bracket for the vehicles dashboard. Onto the ProClip you can install e.g. a holder for your mobile phone or PDA or a handsfree set etc. Safe and convenient -always within easy reach. The ProClip is car specific and easy to install. The installation is quick, no special tools or dismantle of the dashboard is required and it will not damage the interior of the vehicle. Made in black ABS plastic. Comes with detailed instructions. Angled mount Please read all of the instructions and look at the pictures before attaching the ProClip.
1. Peel off the cover of adhesive tape on the ProClip. Align the left lower side of the ProClip with the upper seam of the ash tray door as show in the picture.
2. Hook the angled edge on the right side of the ProClip around the panel frame edge in the side wall. This right side picture shows the back side of the panel the ProClip attaches to, and how the mount clips around the edges. Please note and understand how the notches in the angled edge of the ProClip matches the uneven edge. Based on the alignment the small notches in the ProClip should fit. If not, adjust slightly up/down until it fits.
3. Press the thin end of the enclosed gap opener into the gap/seam between the climate control panel and the console edge, to widen the gap. Press the ProClip to the left so the angled edge on the left side goes into the gap below the gap opener. Press until you see or hear/feel it click into place. Pull out the gap opener.
4. The ProClip is in place.