Brodit ProClip

The ProClip is a mounting bracket for the vehicle’s dashboard. Onto the ProClip you can install e.g. a holder for your mobile phone or PDA or a handsfree set etc. Safe and convenient -always within easy reach. The ProClip is car specific and easy to install. The installation is quick, no special tools or dismantle of the dashboard is required and it will not damage the interior of the vehicle. Made in black ABS plastic. Comes with detailed instructions.

This ProClip can be attached in either position as shown in the pictures or you can have two attached next to each other. The ProClip cannot be attached further to the left than shown in the fourth picture. Center mount Please read all of the instructions and look at the pictures before attaching the ProClip.

1. Use the enclosed alcohol pad to clean the area where the ProClip is to be installed. Peel off the cover of adhesive tape on the ProClip. Press the curved edge on the lower part of the ProClip into the gap between the dashboard and the coin box. Press until you see or hear it clicks into place.

2. Press the thin end of the enclosed gap opener into the gap on top of the dashboard, to widen the gap. Hold the gap opener in an angled position and push firmly forward on the upper part of the ProClip. Push until you see or hear/feel it clicks into the gap next to the gap opener. Pull out the gap opener.

3. This ProClip can be attached in an alternative position as shown in the picture. You can also have two ProClips attached next to each other.

4. The ProClip is in place. The ProClip cannot be attached further to the left than shown in the picture.