Brodit ProClip

The ProClip is a mounting bracket for the vehicle’s dashboard. Onto the ProClip you can install e.g. a holder for your mobile phone or PDA or a handsfree set etc. Safe and convenient -always within easy reach. The ProClip is car specific and easy to install. The installation is quick, no special tools or dismantle of the dashboard is required and it will not damage the interior of the vehicle. Made in black ABS plastic. Comes with detailed instructions. Angled mount Please read all of the instructions and look at the pictures before attaching the ProClip.

1. Use the enclosed alcohol pad to clean the area where the ProClip is to be installed. Press the thin end of the enclosed gap opener into the gap between the center console panel and the padded console edge, to widen the gap. Peel off the cover of adhesive tape on the ProClip.

2. Press the angled edge on the right side of the ProClip into the gap below the gap opener. Pull out the gap opener.

3. Press the gap opener into the gap between the padded center console edge and the console sidewall. Place your index fingers behind the ProClip and pull the angled edge on the left side away from the padded console edge (to avoid scratching of the leather) and hook it into the gap next to the gap opener. To make sure the angled edge is all the way into the gap, place your fingers on each corner of the ProClip and push. Pull out the gap opener.

4. The ProClip is in place.