The ProClip is a mounting bracket for the vehicles dashboard. Onto the ProClip you can install e.g. a holder for your mobile phone or PDA or a handsfree set etc. Safe and convenient -always within easy reach. The ProClip is car specific and easy to install. The installation is quick, no special tools or dismantle of the dashboard is required and it will not damage the interior of the vehicle. Made in black ABS plastic. Comes with detailed instructions. Angled mount Please read all of the instructions and look at the pictures before attaching the ProClip.
1. Use the enclosed alcohol pad to clean the area where the ProClip is to be installed. Press the thin end of the enclosed gap opener into the seam/gap between the center console panel and the padded console edge, to widen the gap. Peel off the cover of adhesive tape on the ProClip.
2. Hold the ProClip in an almost 90 degree angle and press the curved left edge into the gap below the gap opener. Pull out the gap opener.
3. Flip the right side of the ProClip to the right and down, towards the floor, so the curved edge on the left side hooks behind the center console panel.
Press the gap opener up into the gap between the padded console edge and the console sidewall. Press firmly down on the right side of the ProClip so the angled edge hooks into the gap next to the gap opener. Pull out the gap opener.
4. The ProClip is in place.