Brodit ProClip

The ProClip is a mounting bracket for the vehicle’s dashboard. Onto the ProClip you can install e.g. a holder for your mobile phone or PDA or a handsfree set etc. Safe and convenient -always within easy reach. The ProClip is car specific and easy to install. The installation is quick, no special tools or dismantle of the dashboard is required and it will not damage the interior of the vehicle. Made in black ABS plastic. Comes with detailed instructions. Angled mount Please read all of the instructions and look at the pictures before attaching the ProClip.

1. Use the enclosed alcohol pad to clean the area where the ProClip is to be installed. Peel off the cover of adhesive tape on the ProClip. Press the thin curved edge into the seam/gap between the panel frame surrounding the air vent and the padded part of the dashboard. Press forward and then flip the ProClip down so the curved edge on the upper part of the ProClip hooks behind the panel surrounding the air vent.

2. Press the thin end of the enclosed gap opener into the seam/gap between the dashboard and the dashboard overhang next to the ProClip, to widen the gap. Place your index finger on the lower inside of the ProClip. Pull down and hook the angled edge into the seam/gap next to the gap opener.

3. Place your finger underneath the lower part of the ProClip and push upwards to make sure the angled edge is all the way into the gap. Pull out the gap opener.

4. The ProClip is in place.