Brodit ProClip

The ProClip is a mounting bracket for the vehicle’s dashboard. Onto the ProClip you can install e.g. a holder for your mobile phone or PDA or a handsfree set etc. Safe and convenient -always within easy reach. The ProClip is car specific and easy to install. The installation is quick, no special tools or dismantle of the dashboard is required and it will not damage the interior of the vehicle. Made in black ABS plastic. Comes with detailed instructions. Left mount Please read all of the instructions and look at the pictures before attaching the ProClip.

1. Use the enclosed alcohol pad to clean the area where the ProClip is to be installed. Peel off the cover of adhesive tape on the ProClip. Place the angled edge on the lower part of the ProClip into the bottom part of the air vent. Press it down into the seam/gap between the air vent and the surrounding panel frame. Note: if the angled edge is hard to get into the gap, pull firmly towards you so the surrounding panel frame flexes slightly towards you and then press the angled edge into the gap.

2. Press firmly down on top of the ProClip so it flexes downward. Hook the angled edge into the seam/gap between the air vent and the surrounding panel frame.

3. Place your index finger underneath the upper part of the ProClip. Push upward to make sure the angled edge is all the way into the gap.

4. The ProClip is in place.