Performance
| Noise level |
45 dB |
| Audible alarm(s) |
Y |
Power
| Input operation voltage (max) |
147 V |
| Input operation voltage (min) |
90 V |
| Power supply input frequency |
60 Hz |
| Output power capacity |
500 VA |
| Output power |
300 W |
Ports & interfaces
| Modem (RJ-11) ports |
1 |
| AC outlets quantity |
6 |
Battery
| Battery recharge time |
6 h |
| Typical backup time at half load |
10 min |
| Typical backup time at full load |
4 min |
Other features
| Nominal input voltage |
120 V |
| Nominal output voltage |
120 V |
Additionally
| Ethernet LAN (RJ-45) ports quantity |
1 |
300W, 500VA, 4.6kg, Black
G-UPR is a line interactive UPS with Energy Saving Technology. Eliminates charges “ghost” of equipment when they don´t need energy. All models, 500VA, 750VA and 900VA have 6 shots, 3 green (ECO), 2 for router and modem (black) and 1 Bypass (yellow). The factory default programmed environmental function but has selector switches to normal function.
- Environment function or normal operation selector.
- Three (3) outlets that suspend power to shut down the PC.
- Two (2) outlets designed to Modem or Router that keeps WIFI operating for hours.
- Built-in voltage regulator.
- Low battery warning, audible and visual.
- Advanced surge suppressor AC and Data.
- Protected internal, external and firmware overhead
Controlled by CPU, calculates the demand for maximum use of the reserve batteries without damaging them and extend equipment life.
Green Mode: When you plug the UPS is automatically activated, the green LED flashes. In this mode, the UPS is in this mode, ECO (green) outlets haven´t energy. In case of power failure, only have backup black outlets.
ECO Mode: Just hold the power button for 3 seconds (steady green LED), will energize ECO outlets. It is recommended to connect these CDP, Monitor, Speakers, etc. So that by turning off the CPU within a minute the UPS automatically shuts off avoids consumption by Standby. In the event of a power failure the UPS will provide battery backup to all yellow outlets (Bypass) and to return to service must press the power button for 3 seconds to activate again.
Autorun mode: Green and yellow LED on, it all takes are energized, but the ECO mode is disabled and if any peripheral is connected during CPU shutdown, these will be turned on (no power saving). Also, after a power outage the UPS will star automatically.
