Performance
Heat dissipation |
458 BTU/h |
Concurrent connections |
1000000 |
Noise level |
67.9 dB |
System requirements
Minimum flash memory |
8192 MB |
Ports & interfaces
Serial ports quantity |
1 |
Gigabit Ethernet (copper) ports quantity |
6 |
Security
VPN support |
3DES/AES |
Security algorithms |
3DES |
Storage
Solid-state drive capacity |
120 GB |
Number of hard drives installed |
1 |
Total storage capacity |
120 GB |
RAID support |
Y |
Storage media type |
SSD |
Data transmission
VPN throughput |
700 Mbit/s |
Mobile VPN IPSec |
5000 |
Mobile VPN SSL |
2 |
IPS/IDS throughput |
1300 Mbit/s |
Firewall throughput |
2000 Mbit/s |
Maximum firewall connections per second |
50000 |
Power
Number of power supply units |
1 |
Peak power |
134 W |
Input current |
15 A |
Design
Form factor |
1U |
Rack mounting |
Y |
Operational conditions
Non-operating altitude |
0 - 4572 m |
Operating altitude |
0 - 3050 m |
Additionally
Transfer rate (Mbps) |
4000 Mbit/s |
Wireless technologies |
Wired |
ASA 5555-X with SW 8GE Data 1GE Mgmt AC 3DES/AES
Problem Description
ASA 5500-X security appliances that shipped from March 16, 2012 through June 11, 2012 contain the incorrect factory default configuration. This requires the user to follow special procedures for system initialization.
Background
The ASA 5500-X appliances shipped from March 16, 2012 through June 11, 2012 were not loaded with the correct factory default configuration and must be initialized using special commands. The procedures contained in the Quick Start Guide are insufficient to properly initialize the affected units.
Problem Symptoms
Users attempting to initialize the affected ASA 5500-X appliances using the Quick Start Guide will observe that the management 0/0 ports are in the down/down condition. In addition, ASDM for on box management is not accessible.
Workaround/Solution
The factory default configuration can be applied using the following command:
config factory-default
Note that the ASA 5515-X appliance does not support the command above due to Cisco bug ID CSCtz73669. The unit must be restored to the factory default configuration using the command series shown below.