D-Link Systems 3m HDF-400 Low Loss Extension Cable with Nplug to Njack

3-metre extension cable for indooor/outdoor use D-Link, the industry pioneer in wireless networking,
introduces the D-Link ANT24-CB03N, ANT24-
CB06N, and ANT24-CB09N Antenna RF Cables.
These products are designed for outdoor or rooftop
installations when distance between a wireless
Access Point (AP) and an antenna is required. With
these Radio Frequency (RF) cables and D-Link’s
ANT24 line of outdoor antennas, an indoor wireless
AP/Bridge can be used in an outdoor deployment*.
The D-Link ANT24 Antenna RF Cables are available
in three lengths: 3m (9.84ft); 6m (19.68ft); and 9m
(29.52ft). All of them can be inter-connected. On
one end of each cable is an “N-plug” and on the
other end is an “N-jack” with high-quality N-type
connectors.
The D-Link Antenna RF Cables are based on the
HDF-400 specification to minimize the signal loss
introduced to a wireless LAN. The frequency
responses of the cables coincide with the 2.4GHz
ISM band so that the cables are ideal for both IEEE
802.11b and IEEE 802.11g WLANs. With 50 ohms
of impedance, the RF cables can be used with most
D-Link WLAN products. This impedance match
eliminates any Voltage Standing Wave (VSW) issues
in an RF circuit, and any noticeable decrease in the
amplitude of the RF signal.
D-Link includes a RF pigtail adapter in N-type and
SMA connectors with each of its ANT24 antennas.
The D-Link Antenna Cables can be easily installed
with surge protectors and D-Link Wireless APs.
Using these reliable pre-cut RF cables with their
pre-installed connectors ensures that the WLAN
equipment operates optimally, providing the best
performance possible. With a ANT24 Cable,
deployment of an outdoor WLAN is now easier and
more flexible than ever!