Eaton Volt free contact & Remote Power Off Communication Card

Provides UPS status via voltage free contacts, 2x DB9 ports, compatible with Power Management The Volt-free contacts and Remote Power Off communication card may be used in any
UPSs equipped with UPS BUS communication slots as well as in the
MultiSlot module.

<i>This card has two DB9 ports.</i>

One Basic port:
&#9687; provides UPS status via voltage free contacts (AS400 type),
&#9687; monitors a remote power off signal, compatible with Power Management from Windows NT.

One Remote Power Off/Basic port:
&#9687; monitors a remote power off contact (Caution: this remote power off contact cannot be used as Emergency Power Off because a few seconds are needed to stop the unit),
&#9687; or operates as the Basic port.

<i>The Basic status information are as follows:</i>

&#9687; Battery fault,
&#9687; Operation on mains (not on battery),
&#9687; Operation on automatic by-pass,
&#9687; Low battery,
&#9687; Load protected,
&#9687; Operation on battery.