Data transmission
MAC address table |
1000 entries |
Supported data transfer rates |
10/100/1000 Mbps |
Networking
Auto MDI/MDI-X |
Y |
10G support |
N |
Ports & interfaces
Basic switching RJ-45 Ethernet ports quantity |
5 |
DC-in jack |
Y |
Power
Input voltage |
5 V |
Input current |
1 A |
Power over Ethernet (PoE)
Power over Ethernet (PoE) |
N |
5 Ports Gigabit Ethernet Switch, White
- Complies with the IEEE 802.3 , IEEE 802.3u and IEEE 802.3ab standards
- Smart Green Ethernet technology to reduce power consumption 30%~50%.
- Supports Auto-MDI/MDI-X, full/half duplex modes and auto-negotiation
- Supports flow control , Non-blocking and Jumbo Frame
Smart Green ethernet and Gigabit speeds
Take advantage of energy-saving solutions with increased transfer capacities with Edimax’s ES-5500G. It is an ideal energy-saving switch integrated with five 10/100/1000Mbps gigabit ports designed to meet the demands of transferring large files across the network in shorter periods. With built-in Ethernet cable-length detection, the switch automatically supplies the right amount of energy to each connection. It also reduces power consumption if ports are idle.
Supports Wire-speed and Flow Control
The ES-5500G complies with IEEE802.3, IEEE802.3u and IEEE802.3ab standards. Use it to create a gigabit high-speed network, and benefit from its ultimate performance and reliability. The switch uses non-blocking switching architecture to provide your network with full-wire speed connections. It accommodates flow control for full-duplex mode and back pressure for half-duplex mode, which ensure reliable data transfer and help prevent data loss.
Supports Jumbo Frame
In addition, the ES-5500G supports jumbo frame that allows the extension of the Ethernet frame size to a maximum of 9600 bytes for increased data rates. This cost-efficient switch is the best choice for Small office/Home office needs.
Supports AUTO-MDI/MDI-X
It exemplifies the easy “plug and play” installation, because ES-5500G supports auto-MDI/MDI-X. Use either straight-through or cross-over Ethernet cable and combine 10, 100 and 1000 Mbps devices into ES-5500G. The switch will automatically detect the right cable and speed for your device.