Kurth Electronic CCTS-02 Black

Kurth Electronic CCTS-02 Black

MPN: 0.49616
🚚 Select the country of delivery:
Delivery from:
Germany
Updating price ... 📣 Send Price inquiry Не поставляется
Delivery cost & estimated delivery time:
От
days

Where to buy and prices (Advertising *)

On Top
в наличии
* Alle Preise inkl. der jeweils geltenden gesetzlichen Mehrwertsteuer, ggfs. zzgl. Versandkosten. Alle Angaben ohne Gewähr. Preisänderungen sind in der Zwischenzeit möglich.

Technical specifications

On Top
CCTS-02 Cable Conductor Test Set - indispensable for fault tracking, maintainance, setup
- useful also on powerde telecom lines
- line resistance up to 2000 Ohm
- Microprocessor for tuning on life lines
- xDSL and Data safe
- over voltage protected

CCTS02 cable conductor test set is used in a set of two. Two (or more) technicians are able to setup a communications path over dead lines up to 3000 Ohms or more. Be carefull - only on dry telephone lines it is possible to setup communications. Don`t use it on life power lines.

After a new cable installation or after repair a cable in service, the cable has to be tested for common faults like pair reversals, opens, shorts or ground faults.
These tests are fast and easy to handle with CCTS02.

To establish voice communication over a dead pair, plug the headset into the jack on the left side. Turn CCTS02 on. The red ON LED indicates that the unit is on. Connect the black talk leads to a empty pair on the cable. There is no special polarity. If both units are connected to the same pair, voice communication is established. To test wires, one unit has to be in RX-mode and one in TX-mode.
The test tone is audible in both headsets when the red test lead is in contact with the same conductor under test.

If the pair is in service, it is sometimes, especially if xDSL or ISDN service is on the line, impossible to find a single wire Tip (A) or Ring (B). This because the impedance between the wires of a pair is very low ( i.e. 120 Ohms). CCTS02 Microprocessor technology tunes the unit to the resistance of one wire. After it is possible to find wires with low resistance differences to the corresponding wire in a pair.
This saves time - no need for open the line on the MDF.

The electronic circuits are protected by a solid housing made of ABS. To protect the units they are stored in a pouch of strong cordura. The battery compartment is separated and closed by captive screws. CCTS02 needs a standart 9 Volt alkaline battery.

CCTS02 comes with solid test leads with 4mm banana plugs, solid clips and test tip. There is a lightweight and noise compensated headset and a special headset to use in conjunction with a hard hat.
Фотографии

    Password recovery
    To recover your password, please enter in the box below your email address with which you have registered:
    The password reset code has been sent to your Email.
    Код уже был отправлен Вам ранее.
    Вы можете ввести его в поле выше, или получить новый код через сек.
    An error has occurred. Please check your e-mail address and try again.
    Ваш новый пароль:

    Name is empty


    Выберите страну доставки

    You have not written a message

    By clicking on the "Send" button, you agree that your data will be used to process your request. Further information and revocation instructions can be found in the data protection declaration.

    Your message has been sent!

    Close

    1
    Catalog
    Cancel Close
    Бренды:
      Выберите бренды
        Show more close
          Area search
          Worldwide
          Категории
            Product